|
Adhesives
for Attaching Nesco Products to Stucco II |
||||
|
|
||||
We recommend a urethane-based adhesive that maintains its flexibility for the correct installation of our products. For shutters: a continuous bead of adhesive/sealant should be applied around the backing of the piece and cross hatched every 6" -8" inches in between. All other Nesco items should have adhesive/sealant applied inside or on back of item where it will be attached to other materials. These adhesives should also be used in combination with mechanical fasteners. Fasteners should be coarse thread deck or coated dry- wall screws of sufficient length to penetrate the stucco and the backing by at least 1"inch. They should be installed at an upward angle of about 15 degrees and covered over with adhesive to seal the hole in the stucco to prevent moisture penetration. Adhere urethane-to-urethane joints (as in split columns) with two-part epoxy (3M #2216 or equal) following that product's application instructions. Primer and sealer should be removed where the glue/epoxy will be applied to ensure proper adhesion. If you choose: screw holes and joints can be filled with bondo, sanded (if smooth finish) and sealed. Do not apply bondo over any painted surface as it will not stick and will cause blistering and paint failure. Un-sanded bondo will also cause paint blistering. Always use mechanical fasteners-never just use adhesive alone-to install Nesco products. Also, be sure that all screws are in solid structural material-not just the stucco and foam coatings!! 
|
|
|
|
To Contact Us:
Phone: 480.756.6675
Fax: 480.756.6679
Sales@Nescomfg.com
Nesco Manufacturing, Inc.
1510 West Drake Tempe, AZ 85283
Nesco Manufacturing, Inc. website maintained by Compusystemz.
Email our webmaster with any questions or comments regarding this site.
Mail To: sales@compusystemz.com
copyright © 1999-2007 - All rights reserved