Arabesque Window Installation     

                      

                                      Arabesque Window Set Installation (2 piece set)

      ®      Install window set during framing stage

®      Place the window with the double lip on the floor face down 

®      Place the window with the single lip onto the double lip face up

®      Align center openings and attach top half to the bottom half with coarse thread deck or coated drywall screws (see diagram)

®      Set window in opening and attach from outside of framing on all sides, top, and bottom using above-mentioned metal fasteners

®      Be sure that square corners of opening are level

                              Plant-On Application Only (1 piece)

®      Install at trim or stucco stage

®      Arabesque window facades should be applied with adhesivesóacceptable adhesives are those with a urethane base containing a petroleum solvent, such as Polyurethane Sealant #6000 by Silicones Unlimited (available at Nesco Mfg.), ChemRex #948 by ChemRex, Inc., Vulkem #116 by Tremco, PL Premium Construction Adhesive, PL #200 or PL Polyurethane Sealant available at most Loweís & Home Depotóin combination with mechanical fasteners

®      Fasteners should be coarse thread deck or coated drywall screws of sufficient length to penetrate the stucco and the backing material by at least 1î inch

®      They should be installed at an upward angle of about 15 degrees and be covered with an adhesive that will seal the hole in the stucco

®      A continuous bead of adhesive should also be applied around the entire perimeter of the piece and cross hatched every 6î ñ8î inches in between

®      Screw holes are to be sanded, filled with bondo, sanded again and sealedónote: Do not apply bondo over any painted surface as it will not stick and will cause blistering and paint failure.  Unsanded bondo will also cause blistering

                                      

To Contact Us:

Phone:  480.756.6675
Fax:  480.756.6679
Sales@Nescomfg.com

Nesco Manufacturing, Inc.
1510 West Drake Tempe, AZ  85283


Nesco Manufacturing, Inc. website designed and maintained by Site Solutions.
Email our webmaster with any questions or comments regarding this site.
Mail To:  webmaster@sitesolutions.nu
copyright
© 1999-2007 - All rights reserved